Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
[quote=598989]It can happen with any string ... it is a matter of getting the string and cable tensions balanced. It sounds like the string and cable have crept and the string is out of balance between the upper and lower half, especially if the bowtech twisted only the cable to bring the cam into time and didn't correct the string creep as well. This article addresses what you can do now without tools.
Take a pair of needle nosed pliers, insert into the D-Loop, open the pliers as hard as you can. This should tighten the D-Loop knots so that they don't move easily. Since you are into bow season, you won't want to start working on the string/cable tensions, bow specs, cam timing, etc. since you'll end up having to retune and then broadhead tune again. If the bow is shooting broadheads OK, just tighten the D-Loop and adjust it to keep the peep square at full draw ... if that doesn't pan out, then another fix is to retie the peep in using the Fletcher method. You can correct peep alignment at full draw by sliding the upper and lower knots on the string either closer or farther away.
Get the string and cable tensions even and the upper and lower half of the string in balance after bow season ... FWIW, that's what I'd do.
[/quote] Yeah my broad heads are shooting great and I thought I was good to go as it hadn't been rotating after they put a twist in I believe the cable and something with the string as well. I didn't have this problem with the last set of strings and cabela that they made me. I did try to moving the d-loop and it works for a few shot but semis to eventually go back to rotating a few degrees. I even tried fighting with the needle nose pliers as you mention and the same same thing happened after a few shots. The knots just seem to turn easier than I would think it should. Also sometimes when the bow isn't drawn the d-loop is facing back toward center and other time it will be off to one side. The same goes for the direction the peep is facing when the bow isn't drawn. What I don't understand is the rotation isn't consistent. Sometimes it is more degrees than others and it is usually right but the other day in the stand it went left but today it was back to being right. I can get it centered put it away and the next day it will be rotating off and on. Thanks for the links to the article and videos I will defiantly have watch them.
Reason for Reporting