Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
The bow had cam lean at full draw. At one point I flipped the cables on the rollers, moving the top cable to the inside, to take out some of the lateral pull. It helped until the yoke self-adjusted after quite a bit of shooting...evidence of the tight yoke in the ring you're talking about. The bottom line, the cam just would not line up straight and it should. What kills me is the bottom cam was fine but the shop told me Mathews sent limbs for the bottom and the top, so the shop replaced both which did not fix the top and caused the bottom to lean also. After more than a month, I had no choice but to give up. Keep in mind, I had to wait more than three weeks to receive the bow on order so I had a total of two months time invested in this purchase.
Reason for Reporting