Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
The edge of the inside of the limb - near where the limb splits, has been rubbing on the cam for awhile...I don't recall hearing it during the draw or shot cycle - just saw the wear when I was replacing my string and cable. I checked the bushing very carefully and it seemed fine..no wobble smooth and quiet, the axle itself rolls forever on a flat floor...when I put the cam back in the limb, it will rub while spinning around the axle-right at the spot shown on the attached photo... I didn't hear back from you guys for over a week, nor my dealer who I bought the bow from back east, nor a local dealer (where I left a message)...which wasn't the best situation... So I put it all back together with new strings and cables and tuned the idler and timed the cam and I can't hear it rub...I'll paper tune it the next couple of days - but just in the shooting to seat the d-loop and let the peep settle in, it seems to shoot much, much better... My theory is either: string wear had it rubbing slightly as the cam came back to rest during a shot cylce (cam outta time maybe - but never heard of such) or - I suppose its possible the limb's axle holes are not perfectly plumb... Suggestions? Tom
Reason for Reporting