Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
Sorry didn't see this BOC...ALways try to install the strings as a set... I remove both string and cable install cable with [pending on what string] 7 twist bows right yoke and 3 twists on bows left yoke....CCW to strings CW [Clock Wise ] twist...install as makers twists already on string....some company's get it so close its scary.... Than install string....also as maker shipped....it will usually be taped ..thats because it has proper or close twists already on string.... take bow out of press draw 3-5 times using entire hand....or load with arrow pointed in safe location and draw with release... check poundage...put back on press and then check specs....twist till dead on.. *.points....remember to spec tune with bow maxed out snug...twisting cable moves specs quickly...ATA poundage .... We spec tune so ATA is 1/16 short and cable runs below center line in timing window...[in case of older bows....timing holes straight edge slightly approx 1/4" on idler wheel end.. towards riser
Reason for Reporting