Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
Additions to the "Guide"... [u:3844vs6j]Helim[/u:3844vs6j] *Grub 1 1/4" from where string leaves cam to bottom of grub...as there is no string suppressor to measure from...Note Thats with Cam alignment/timing cable centered in window...if high or low allow for that 1 1/4 measurement... *Idler wheel lean is closer to string than most models...some even in line with straight edge at nock point. * The HeliM really shoots well slightly low in alignment/timing window and ATA 1/16 short...which is standard specs when we retune spec on the HeliM. * Assure that set screws are always tight on roller guard, Dead Stop and modular on cam...as these have been known to loosen on the Helim, Blue locktite can be used to secure as the Blue will break free when needed.. [img]http://forums.mathewsinc.com/images/userpix/6673_8674_Untitled1_186_2.jpg[/img]
Reason for Reporting