Report Forum Post
*Note - This report is sent only to the Forum Moderators, no other user will see this.
Now the top and bottom can be put on. The larger panels you set aside are used for these, and they will have to be trimmed down to fit. They are the correct width already, so make sure you trim the right edge off. Set the three panels upright and install the top, then flip it over and do the bottom. The bottom should be 3/4" longer than the sides. Remember, the front needs to be installed yet and it will fit inside the bottom and top. Here is a picture of the bottom. (The smoker is upside down in this picture). [img]http://rp.smugmug.com/photos/94131406-M.jpg[/img] Here is a picture of the top and bottom installed. See how the bottom protrudes out 3/4". I leave the top longer, instead of having it stick out 3/4" I like to leave it out about 3 inches. It gives the appearance of having a small overhang, sort of like a little roof overhang. It just looks nice. [img]http://rp.smugmug.com/photos/94131469-M.jpg[/img]
Reason for Reporting