Need help getting limb bolts for an Icon

Home Forums Archery Tech Forum Need help getting limb bolts for an Icon

This topic contains 3 replies, has 2 contributors, and was last updated by  murinus 1 year, 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 19, 2013 at 8:55 pm #578356 Back to Top REPORT

    murinus

    Joined: 2/5/2012
    Hi guys

    I’m wondering if anyone is able to help me get a couple of limb bolts for my Mathews Icon? I accidentally stripped the head of the limb bolt while turning it, so I’m hoping to get a replacement and another as spare.
    I am not based in the US, and the only Mathews dealer in my country does not stock the limb bolts. The dealer asked me to try the hardware stores, but I couldn’t find a suitable sized bolt. I even tried some online fastener supply shops but they don’t have the size I need.
    I’m consolidating a few online orders now, so it would be great if anyone can help to send a couple of limb bolts to an address in Oregon. I believe the size is 3/8 x 24tpi 2 3/4″. I will pay for the costs of the limb bolts and shipping. Thank you!
    May 20, 2013 at 4:43 am #578370 Back to Top REPORT

    murinus

    Joined: 2/5/2012
    I was referred to a link on Amazon which seems to have the correct sized bolt. I just dropped a message to the seller to check on the length of the threaded portion. If its the same as the one for the Icon then I’m getting it from there :)
    May 20, 2013 at 7:19 am #578372 Back to Top REPORT
    lunzee
    Lunzee

    Joined: 12/21/2010
    Have you tried contacting Mathews on your issue?  They might be able to help you out.{#emotions_dlg.mathews_thumbs_up}
    June 18, 2013 at 8:41 am #581462 Back to Top REPORT

    murinus

    Joined: 2/5/2012
    The thread length of the new screws I ordered were too short, although the overall length of the screws were the same. I could not tighten the limbs all the way down since the threads were too short and wasted $15 just on the shipping to find out they can’t fit {#emotions_dlg.mathews_crying}

    Can anyone who bought new limb bolts before share where they got theirs? Or anyone has a Mathews dealer nearby who has the limb bolts in stock? The limb bolt for the Icon is a 3/8 x 24, 2 3/4″ flat head socket screw.

    I tried writing to Mathews but didn’t get a response from them.

Viewing 4 posts - 1 through 4 (of 4 total)