Gap at bearing

Dear Mathews Family –

We're excited to announce the launch of the all-new Mathewsinc.com coming very soon. We appreciate the support and feedback of this active online community, however, we will not be hosting a forum on the new site. We invite you to connect with us and each other on social media and other forums (Facebook, Instagram, Twitter, Bowsite.com, Bowhunting.com and Archerytalk.com), where your passion and experience can be shared with a wider audience to help grow this sport.

Home Forums Technical FAQ Gap at bearing

Tagged: , ,

This topic contains 0 replies, has 1 voice, and was last updated by  Alan Lee 1 year, 6 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • July 15, 2014 at 10:22 am #633499 Back to Top REPORT

    Alan Lee

    Joined: 10/14/2010
    Anyone encountered this. My C4’s idler pulley can slide over the bearing resulting in the bow string moving left and right approx  5mm.  Is the pulley worn?  The gap is just on one side, I think the hole where the bearing sits is oval and no longer round.  little strength needed to press bearings out of the pulley with fingers.

Viewing 1 post (of 1 total)