Conquest Set Up Help

Home Forums Archery Tech Forum Conquest Set Up Help

This topic contains 5 replies, has 3 contributors, and was last updated by stevejo Stevejo 1 year ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 7, 2013 at 3:32 pm #609861 Back to Top REPORT
    stevejo
    Stevejo

    Joined: 8/4/2013
    Photo Gallery
    Hi, I have a Conquest Pro I am setting up.
    It has a Z CCR HLcam which should offer 29″ draw when set on pegs 1/1 which is where it is now.

    Does anyone have a picture of the cam timing for this cam?

    Thanks

    December 7, 2013 at 4:31 pm #609876 Back to Top REPORT
    stevejo
    Stevejo

    Joined: 8/4/2013
    Photo Gallery
    Okay, I found what I needed.  I have the above bow / cam.
    ATA = 41.0″
    BH = 7.25″ (long by .25″)
    DL = 31″ (long by 1″ for this Cam)

    any thoughts on what could be the culprit here?
    Im gonna pull the string and cables and make sure they are at factory spec

    December 7, 2013 at 6:18 pm #609882 Back to Top REPORT
    stevejo
    Stevejo

    Joined: 8/4/2013
    Photo Gallery
    Hmmm…
    So the string and cables are right on the money and it is still a full inch too long.

    I have a Focus grip on it which I’m sure adds something to the draw length

    I understand the draw runs a bit long on the older bows.  Think that would account for an inch?

    Any thoughts are greatly appreciated.

    Thanks
    Joe

    December 8, 2013 at 12:21 pm #609969 Back to Top REPORT

    Gary Wiant

    Joined: 7/2/2010
    Location: Pennsylvania
    Not sure about type bow but when I had my triumph 32″ cams measured 32 5/8″ with the focus grip so without it you’d add a bit more
    Gary Wiant 2013 Mathews MR7 70# 32" Camp 2014 Mathews Apex 8 60# Blue Smoke Stan Prostaff
    December 10, 2013 at 6:22 pm #610369 Back to Top REPORT

    Q2XLMAN

    Joined: 7/11/2004
    a zccr cam on a conquest pro should be 30″ in your 1st post u said it should be 29″ in your 2nd post u said it was 31″ and was an inch long ..

    also draw length is measured from the string to the front of the riser at full drawon a conquest pro grip doesnt make ANY difference .

    December 11, 2013 at 11:56 am #610427 Back to Top REPORT
    stevejo
    Stevejo

    Joined: 8/4/2013
    Photo Gallery
    Thanks for the reply.
    I ended up putting a shorter draw length cam on it and that got it where I needed it for practical use.  Just gives an ice cream headache not knowing why this one is so much longer than my others.
Viewing 6 posts - 1 through 6 (of 6 total)